GCSE Physics Foundation Paper 2
Covers Energy Stores, Transfers and Conservation, Energy Resources and Efficiency, Electrical Circuits and Components and 9 more.
Questions
Question 1 [2 marks]
Domestic Electricity and Power
A torch uses a battery to power its bulb, while the UK mains electricity supply is alternating current (a.c.).
State what is meant by 'direct current', and state one difference between direct current and alternating current.
Question 2 [2 marks]
Energy Stores, Transfers and Conservation
A stone is thrown vertically upwards. It rises to its highest point and then falls back down to the height it was thrown from. Ignore air resistance.
State the energy store the stone's kinetic energy is transferred to as it rises, and state the energy store this is transferred back to as the stone falls.
Question 3 [2 marks]
Particle Model of Matter
A beaker of water is heated from 20 deg C until it boils and turns to steam.
State what happens to the arrangement and movement of the water particles as the water changes from a liquid to a gas (steam).
Question 4 [2 marks]
Magnetism and Electromagnetism
A bar magnet is a permanent magnet, while a solenoid connected to a battery is an electromagnet.
State one similarity and one difference between a permanent magnet and an electromagnet.
Question 5 [3 marks]
Wave Properties and Behaviour
A water wave has a frequency of 2.5 Hz and a wavelength of 0.8 m.
Calculate the speed of the wave.
Question 6 [3 marks]
Atomic Structure and Radioactivity
Alpha, beta and gamma are three types of radiation emitted by unstable, radioactive nuclei.
Describe what an alpha particle is, and describe its penetrating power and ionising power compared with beta and gamma radiation.
Question 7 [3 marks]
Moments, Elasticity and Pressure
A force of 25 N is applied at a distance of 0.6 m from a pivot, perpendicular to the arm it acts on.
Calculate the moment of the force about the pivot.
Question 8 [4 marks]
Electrical Circuits and Components
Two identical fairy lights are wired in series with a battery.
State how the current through each lamp compares with the current through the other. State what happens to the other lamp if one filament breaks, and explain why. Then state why this makes it harder to locate the failed lamp than in a parallel circuit.
Question 9 [4 marks]
Energy Resources and Efficiency
Nuclear power and natural gas are both used to generate electricity in the UK.
State whether nuclear power is renewable or non-renewable and explain your choice. Explain why nuclear power is described as low-carbon, and give one advantage it has over wind and solar power.
Question 10 [5 marks]
Space Physics
Stars form from clouds of dust and gas in space, called nebulae.
Describe how a star like the Sun forms from a nebula, up to the point where it becomes a stable main sequence star.
Question 11 [5 marks]
Momentum and Forces in Action
A car of mass 800 kg travelling at 15 m/s collides with a second car of mass 1200 kg travelling at 5 m/s in the same direction. After the collision, the two cars move together with a common velocity.
Calculate the total momentum before the collision, and the common velocity of the two cars after the collision.
Question 12 [5 marks]
Forces, Motion and Newton's Laws
A car travels at a constant speed, covering 144 m in 12 s. The driver then brakes, and the car decelerates uniformly from this speed to rest in a further 4 s.
Calculate the car's constant speed before braking, and then calculate its deceleration while braking.
Question 13 [5 marks]
Energy Stores, Transfers and Conservation
A 2 kg block of copper is initially at 150 deg C and cools down, releasing 30,800 J of energy to the surroundings. The specific heat capacity of copper is 385 J/kg deg C.
Calculate the fall in temperature of the block, and hence calculate its final temperature.
Question 14 [5 marks]
Domestic Electricity and Power
A microwave oven has a constant electrical input power of 800 W. It is used for 3 minutes to heat a meal.
Calculate the energy transferred by the microwave oven, in joules, and then in kilowatt-hours (kWh).
Question 15 [5 marks]
Energy Resources and Efficiency
A solar panel receives 1000 W of power from sunlight and produces 180 W of useful electrical power.
Calculate the efficiency of the solar panel. State the theoretical maximum efficiency any device could have, and state where most of the wasted power is dissipated to.
Question 16 [5 marks]
Atomic Structure and Radioactivity
Some radioactive nuclei decay by emitting an alpha particle.
State what happens to the mass number and the atomic number of a nucleus when it emits an alpha particle, giving a reason for each. Then state one common source of background radiation involving alpha-emitting materials.
Model solutions
| Question 1[2 marks] | |
|---|---|
| Answer or working | Marks |
| direct current flowing in one direction only | B1 |
| the contrasting behaviour of alternating current: it repeatedly reverses direction; do not credit the direct-current definition again | B1 |
| Final answer: Direct current flows in one direction only. Alternating current repeatedly reverses direction. | |
| Question 2[2 marks] | |
|---|---|
| Answer or working | Marks |
| the gravitational potential energy store, as the stone rises | B1 |
| the gravitational potential energy store being transferred back to the kinetic energy store as the stone falls | B1 |
| Final answer: Kinetic energy is transferred to the gravitational potential energy store as the stone rises, and back to the kinetic energy store as it falls. | |
| Question 3[2 marks] | |
|---|---|
| Answer or working | Marks |
| the particles become much further apart, moving from a close, random arrangement to a widely spaced arrangement | B1 |
| particles moving freely and randomly in all directions rather than remaining close while moving past one another; do not require an increase in average speed during boiling | B1 |
| Final answer: Particles change from a close, disordered liquid arrangement to a widely spaced gas and move freely and randomly in all directions. Heating before boiling increases average speed; during boiling at constant temperature, average kinetic energy does not increase. | |
| Question 4[2 marks] | |
|---|---|
| Answer or working | Marks |
| a similarity: both produce a magnetic field with a north pole and a south pole | B1 |
| one valid difference: the electromagnet can be switched on/off by controlling current, or its strength can be adjusted through current; a permanent magnet maintains a field without current | B1 |
| Final answer: Both produce a magnetic field with a north and south pole; unlike a permanent magnet, an electromagnet's field can be switched on/off and adjusted by changing the current. | |
| Question 5[3 marks] | |
|---|---|
| Answer or working | Marks |
| wave speed = frequency x wavelength | M1 |
| substituting 2.5 x 0.8 | M1 |
| wave speed = 2 m/s | A1 |
| Final answer: 2 m/s | |
| Question 6[3 marks] | |
|---|---|
| Answer or working | Marks |
| an alpha particle consisting of 2 protons and 2 neutrons, the same as a helium nucleus | B1 |
| alpha radiation having a low penetrating power, being absorbed by a sheet of paper or a few cm of air | B1 |
| alpha radiation being strongly ionising, more ionising than beta or gamma radiation | B1 |
| Final answer: An alpha particle is a helium nucleus containing two protons and two neutrons. It has the lowest penetration of alpha, beta and gamma, being stopped by paper or a few centimetres of air. It is the most strongly ionising of the three. | |
| Question 7[3 marks] | |
|---|---|
| Answer or working | Marks |
| moment = force x distance | M1 |
| substituting 25 x 0.6 | M1 |
| moment = 15 N m | A1 |
| Final answer: 15 N m | |
| Question 8[4 marks] | |
|---|---|
| Answer or working | Marks |
| the current through each lamp being the same | B1 |
| stating that if one lamp's filament breaks, the other lamp also goes out (no current flows anywhere in the circuit) | B1 |
| explaining this happens because there is only one path for the current in a series circuit, so breaking it at any point stops the current everywhere | B1 |
| stating that all lamps being dark makes it difficult to identify which lamp has failed | B1 |
| Final answer: The current through both lamps is equal. If one filament breaks, both lamps go out because the circuit has only one path and it is now broken. Since both are dark, it is difficult to identify which lamp has failed. | |
| Question 9[4 marks] | |
|---|---|
| Answer or working | Marks |
| nuclear power being non-renewable | B1 |
| explaining its uranium fuel is finite and is not replenished on a human timescale | B1 |
| explaining fission does not burn fossil fuel and releases very little carbon dioxide during generation; do not require zero lifecycle emissions | B1 |
| an advantage over wind and solar: generation does not depend on wind or sunlight, so it can supply continuous output | B1 |
| Final answer: Nuclear power is non-renewable because uranium fuel is finite and is not replenished on a human timescale. Fission does not burn fossil fuel, so carbon dioxide emissions during generation are very low. It can generate continuously regardless of wind or sunlight. | |
| Question 10[5 marks] | |
|---|---|
| Answer or working | Marks |
| stating gravity (gravitational attraction) pulls the dust and gas in a nebula together over a very long time | B1 |
| stating this forming ball of gas is called a protostar | B1 |
| stating that as the protostar's gravity continues to pull in more matter, it becomes denser and hotter | B1 |
| stating that once the core becomes hot and dense enough, nuclear fusion of hydrogen into helium begins | B1 |
| stating this fusion releases a huge amount of energy, and the outward pressure from the fusion reactions balances the inward pull of gravity, so the star becomes stable, entering the main sequence | B1 |
| Final answer: Gravity pulls the dust and gas in a nebula together, forming a protostar that becomes hotter and denser as more matter is pulled in; once it is hot and dense enough, nuclear fusion of hydrogen into helium begins, and the outward pressure this creates balances gravity, giving a stable main sequence star. | |
| Question 11[5 marks] | |
|---|---|
| Answer or working | Marks |
| total momentum before = (800 x 15) + (1200 x 5) | M1 |
| total momentum before = 18000 kg m/s | A1 |
| using conservation of momentum, common velocity = total momentum / total mass | M1 |
| substituting 18000 / (800 + 1200) | M1 |
| common velocity = 9 m/s | A1 |
| Final answer: Total momentum before = 18000 kg m/s; common velocity after the collision = 9 m/s. | |
| Question 12[5 marks] | |
|---|---|
| Answer or working | Marks |
| speed = distance / time | M1 |
| substituting 144 / 12 | M1 |
| speed = 12 m/s | A1 |
| acceleration = change in velocity / time = (0 - 12) / 4 | M1 |
| deceleration = 3 m/s^2 (acceleration = -3 m/s^2) | A1 |
| Final answer: Constant speed = 12 m/s; deceleration = 3 m/s^2. | |
| Question 13[5 marks] | |
|---|---|
| Answer or working | Marks |
| change in temperature = energy transferred / (mass x specific heat capacity) | M1 |
| substituting 30800 / (2 x 385) | M1 |
| change in temperature = 40 deg C | A1 |
| final temperature = 150 - 40 | M1 |
| final temperature = 110 deg C | A1 |
| Final answer: Fall in temperature = 40 deg C; final temperature = 110 deg C. | |
| Question 14[5 marks] | |
|---|---|
| Answer or working | Marks |
| time = 3 x 60 = 180 s | M1 |
| energy transferred = power x time | M1 |
| energy transferred = 800 x 180 = 144000 J | A1 |
| converting to kWh, using power in kW x time in hours | M1 |
| energy transferred = 0.04 kWh | A1 |
| Final answer: 144000 J (0.04 kWh). | |
| Question 15[5 marks] | |
|---|---|
| Answer or working | Marks |
| efficiency = useful power output / total power input | M1 |
| substituting 180 / 1000 | M1 |
| efficiency = 0.18 (18%) | A1 |
| stating the theoretical maximum efficiency is 1 (100%) | B1 |
| stating unused energy heats the panel and surroundings; accept energy reflected away and subsequently absorbed by the surroundings | B1 |
| Final answer: Efficiency = 180 / 1000 = 0.18 (18%); the theoretical maximum is 1 (100%). The remaining 820 W mainly heats the panel and surroundings. Some sunlight can be reflected away and later absorbed elsewhere. | |
| Question 16[5 marks] | |
|---|---|
| Answer or working | Marks |
| stating the mass number decreases by 4 when an alpha particle is emitted | B1 |
| the reason: an alpha particle itself has a mass number of 4 (2 protons and 2 neutrons), so this many nucleons leave the nucleus | B1 |
| stating the atomic number decreases by 2 | B1 |
| explaining the alpha particle carries away 2 protons | B1 |
| one valid common alpha-emitting background source, such as radon from rocks and soil (accept natural uranium or thorium in rocks) | B1 |
| Final answer: Mass number decreases by 4 and atomic number decreases by 2, since an alpha particle carries away 4 nucleons including 2 protons; radon gas, which can build up indoors, is a common source of alpha background radiation. | |