Revision Library
Choose a subject
Menu
Foundation Tier - Grades 1-5

GCSE Physics Foundation Paper 3

Covers Energy Stores, Transfers and Conservation, Energy Resources and Efficiency, Electrical Circuits and Components and 9 more.

17 questions - 60 marks - calculator allowed

Download PDF

Open GCSE Physics workspace

Questions

Question 1 [2 marks]

Forces, Motion and Newton's Laws

A car is travelling at a constant, steady speed in a straight line along a flat road.

State what this tells you about the resultant force acting on the car, and explain your answer in terms of Newton's First Law.

Question 2 [2 marks]

Atomic Structure and Radioactivity

An atom of sodium has an atomic number of 11 and a mass number of 23.

State the number of protons and the number of neutrons in an atom of this sodium isotope.

Question 3 [2 marks]

Domestic Electricity and Power

A torch uses a battery to power its bulb, while the UK mains electricity supply is alternating current (a.c.).

State what is meant by 'direct current', and state one difference between direct current and alternating current.

Question 4 [3 marks]

Electrical Circuits and Components

A heater element is connected to a 9 V supply. A current of 3 A flows through it.

Calculate the resistance of the heater element.

Question 5 [3 marks]

Wave Properties and Behaviour

A water wave has a frequency of 4 Hz and a wavelength of 1.5 m.

Calculate the speed of the wave.

Question 6 [3 marks]

Particle Model of Matter

A metal block has a mass of 540 g and a volume of 60 cm^3.

Calculate the density of the metal. Give the units of your answer.

Question 7 [3 marks]

Space Physics

A polar orbiting satellite passes over the Earth's poles in a much lower orbit than a geostationary satellite, taking about 100 minutes to complete one orbit, while the Earth continues to rotate beneath it.

State why a polar orbiting satellite does not stay above the same point on the Earth's surface, and state one advantage this type of orbit gives for Earth observation.

Question 8 [3 marks]

Energy Stores, Transfers and Conservation

An electric drill transfers 54,000 J of energy electrically in 45 seconds.

Calculate the power of the drill.

Question 9 [4 marks]

Moments, Elasticity and Pressure

A student uses a long crowbar to lift a heavy rock, placing the pivot (fulcrum) close to the rock and pushing down on the other, much longer end of the crowbar.

State the principle of moments needed for the rock to be lifted, and explain why using a longer crowbar, or placing the pivot closer to the rock, makes it easier (needs less force) to lift the rock.

Question 10 [3 marks]

Energy Resources and Efficiency

An electric motor is supplied with 800 J of electrical energy. It usefully transfers 600 J to the kinetic energy store of a fan, and the rest is wasted, mostly transferred to the thermal energy store of the surroundings due to friction.

Calculate the efficiency of the motor. Give your answer as a percentage.

Question 11 [4 marks]

Magnetism and Electromagnetism

A wire of length 0.6 m is placed at right angles to a magnetic field of flux density 0.15 T. The wire experiences a force of 0.9 N due to the field.

Calculate the current flowing through the wire, and state the rule used to find the direction of the force on a current-carrying wire in a magnetic field.

Question 12 [4 marks]

Electrical Circuits and Components

A current of 3 A flows through a component connected to a 12 V supply for 40 seconds.

Calculate the charge that flows through the component, and hence calculate the energy transferred.

Question 13 [4 marks]

Energy Resources and Efficiency

An electric drone motor is supplied with 150 W of electrical power. The motor has an efficiency of 68%.

Calculate the useful power output of the motor transferred to the drone's propellers, and the power that is wasted.

Question 14 [5 marks]

Momentum and Forces in Action

A car of mass 1000 kg travelling at 12 m/s collides with a second car of mass 500 kg travelling at 6 m/s in the same direction. After the collision, the two cars move together with a common velocity.

Calculate the total momentum before the collision, and the common velocity of the two cars after the collision.

Question 15 [5 marks]

Wave Properties and Behaviour

Sound travels through air at a speed of 340 m/s. A sound wave has a frequency of 850 Hz.

Calculate the wavelength of the sound wave, and its time period.

Question 16 [5 marks]

Particle Model of Matter

A glass marble has a density of 2.5 g/cm^3 and a mass of 40 g.

Calculate the volume of the marble. Then convert this volume into m^3.

Question 17 [5 marks]

Moments, Elasticity and Pressure

A spring has a spring constant of 50 N/m. A force of 7 N is applied to the spring, which stays within its limit of proportionality.

Calculate the extension of the spring, and state the length of the spring if its natural, unstretched length was 22 cm.

Model solutions

Mark scheme for Question 1 [2 marks]
Question 1[2 marks]
Answer or workingMarks
stating the resultant force on the car is zeroB1
explaining Newton's First Law states an object moving at a constant velocity continues to do so unless acted on by a resultant force, so a constant velocity means the forces on the car are balancedB1
Final answer: The resultant force is zero; by Newton's First Law, an object continues at constant velocity unless a resultant force acts on it, so the forces on the car must be balanced.
Mark scheme for Question 2 [2 marks]
Question 2[2 marks]
Answer or workingMarks
11 protons, equal to the atomic numberB1
12 neutrons, since 23 - 11 = 12B1
Final answer: 11 protons and 12 neutrons
Mark scheme for Question 3 [2 marks]
Question 3[2 marks]
Answer or workingMarks
direct current flowing in one direction onlyB1
the contrasting behaviour of alternating current: it repeatedly reverses direction; do not credit the direct-current definition againB1
Final answer: Direct current flows in one direction only. Alternating current repeatedly reverses direction.
Mark scheme for Question 4 [3 marks]
Question 4[3 marks]
Answer or workingMarks
resistance = potential difference / currentM1
substituting 9 / 3M1
resistance = 3 ohmA1
Final answer: 3 ohm
Mark scheme for Question 5 [3 marks]
Question 5[3 marks]
Answer or workingMarks
wave speed = frequency x wavelengthM1
substituting 4 x 1.5M1
wave speed = 6 m/sA1
Final answer: 6 m/s
Mark scheme for Question 6 [3 marks]
Question 6[3 marks]
Answer or workingMarks
density = mass / volumeM1
substituting 540 / 60M1
density = 9 g/cm^3A1
Final answer: 9 g/cm^3
Mark scheme for Question 7 [3 marks]
Question 7[3 marks]
Answer or workingMarks
explaining that motion in a polar orbital plane cannot match the angular motion of a fixed point rotating around Earth's axisB1
explaining that Earth rotates beneath the satellite so successive orbits pass over different surface stripsB1
one Earth-observation advantage, e.g. repeated passes can build broad/global coverage useful for mapping or weather monitoringB1
Final answer: The polar orbital motion does not match the motion of a fixed point rotating with Earth. Earth turns beneath the satellite, so successive passes cover different strips; this lets it build broad or global coverage useful for mapping and weather monitoring.
Mark scheme for Question 8 [3 marks]
Question 8[3 marks]
Answer or workingMarks
power = energy transferred / timeM1
substituting 54000 / 45M1
power = 1200 WA1
Final answer: 1200 W
Mark scheme for Question 9 [4 marks]
Question 9[4 marks]
Answer or workingMarks
moment = force x perpendicular distance from pivot to line of actionB1
the effort moment equalling the resisting load moment at the threshold of lifting, and exceeding it to start rotating the rock upwardsB1
explaining that a longer effort arm increases moment per unit effort force, so the same load moment requires less effortB1
explaining that a pivot closer to the rock reduces the load arm and resisting moment, so less effort is required for the same effort armB1
Final answer: At the threshold of lifting, effort moment equals resisting load moment; the effort moment must exceed it to start lifting. Moment = force x perpendicular lever arm. Lengthening the effort arm gives more turning moment per unit force; shortening the rock's load arm reduces the opposing moment. Both reduce the required effort.
Mark scheme for Question 10 [3 marks]
Question 10[3 marks]
Answer or workingMarks
efficiency = useful output energy transfer / total input energy transferM1
substituting 600 / 800M1
efficiency = 75% (equivalently 0.75 as a fraction, converted to the requested percentage)A1
Final answer: 75%
Mark scheme for Question 11 [4 marks]
Question 11[4 marks]
Answer or workingMarks
force = magnetic flux density x current x length, rearranged to current = force / (flux density x length)M1
substituting 0.9 / (0.15 x 0.6)M1
current = 10 AA1
naming Fleming's left-hand rule as the rule used to find the direction of the forceB1
Final answer: Current = 10 A; Fleming's left-hand rule gives the direction of the force, with the First finger for Field, the seCond finger for Current, and the thuMb for the resulting Motion (force).
Mark scheme for Question 12 [4 marks]
Question 12[4 marks]
Answer or workingMarks
charge = current x timeM1
substituting 3 x 40M1
charge = 120 CA1
energy transferred = charge x potential difference = 120 x 12 = 1440 JA1
Final answer: Charge = 120 C; energy transferred = 1440 J.
Mark scheme for Question 13 [4 marks]
Question 13[4 marks]
Answer or workingMarks
useful power output = efficiency x total power inputM1
substituting 0.68 x 150M1
useful power output = 102 WA1
wasted power = 150 - 102 = 48 WA1
Final answer: Useful power output = 102 W; wasted power = 48 W.
Mark scheme for Question 14 [5 marks]
Question 14[5 marks]
Answer or workingMarks
total momentum before = (1000 x 12) + (500 x 6)M1
total momentum before = 15000 kg m/sA1
using conservation of momentum, common velocity = total momentum / total massM1
substituting 15000 / (1000 + 500)M1
common velocity = 10 m/sA1
Final answer: Total momentum before = 15000 kg m/s; common velocity after the collision = 10 m/s.
Mark scheme for Question 15 [5 marks]
Question 15[5 marks]
Answer or workingMarks
wavelength = wave speed / frequencyM1
substituting 340 / 850M1
wavelength = 0.4 mA1
time period = 1 / frequencyM1
time period = 1 / 850 = 1.18 x 10^-3 s (accept 1.2 x 10^-3 s)A1
Final answer: Wavelength = 0.4 m; time period = 1.18 x 10^-3 s (about 1.2 ms).
Mark scheme for Question 16 [5 marks]
Question 16[5 marks]
Answer or workingMarks
volume = mass / densityM1
substituting 40 / 2.5M1
volume = 16 cm^3A1
converting cm^3 to m^3, using 1 cm^3 = 1 x 10^-6 m^3M1
volume = 1.6 x 10^-5 m^3A1
Final answer: 16 cm^3 (1.6 x 10^-5 m^3).
Mark scheme for Question 17 [5 marks]
Question 17[5 marks]
Answer or workingMarks
extension = force / spring constantM1
substituting 7 / 50M1
extension = 0.14 m (14 cm)A1
new length = natural length + extension = 22 + 14M1
new length = 36 cmA1
Final answer: Extension = 0.14 m (14 cm); new length = 36 cm.

Build a free practice pack.

Pick the topics, add the student's name and print one PDF.