Revision Library
Choose a subject
Menu
Foundation Tier - Year 10

Year 10 Paper 2: Energy and Particles

Covers energy stores and transfers, energy resources and efficiency, electrical circuits, domestic electricity and power, the particle model of matter, and atomic structure.

17 questions - 60 marks - calculator allowed

Year 10 follows a typical teaching order. No exam board defines what belongs to Year 10, and schools sequence the course differently. Check it against your own scheme of work before using it to decide what a class has covered.

Download PDF

Open GCSE Physics workspace

Questions

Question 1 [2 marks]

Atomic Structure and Radioactivity

An atom of aluminium has an atomic number of 13 and a mass number of 27.

State the number of protons and the number of neutrons in an atom of this aluminium isotope.

Question 2 [2 marks]

Energy Stores, Transfers and Conservation

A skier at the top of a snowy hill is stationary. She then skis down the slope, gaining speed.

State the name of the energy store the skier's energy is transferred from, and the energy store it is transferred to as she skis down. Assume no energy is dissipated.

Question 3 [2 marks]

Particle Model of Matter

A beaker of water is heated from 20 deg C until it boils and turns to steam.

State what happens to the arrangement and movement of the water particles as the water changes from a liquid to a gas (steam).

Question 4 [2 marks]

Energy Resources and Efficiency

Biomass and oil are both used as fuels.

State whether biomass is a renewable or non-renewable energy resource, and give one reason why oil is described as a non-renewable resource.

Question 5 [2 marks]

Domestic Electricity and Power

A torch uses a battery to power its bulb, while the UK mains electricity supply is alternating current (a.c.).

State what is meant by 'direct current', and state one difference between direct current and alternating current.

Question 6 [3 marks]

Energy Resources and Efficiency

A student says that using more renewable energy resources for electricity generation in the UK has no disadvantages.

Evaluate this statement by giving three disadvantages of relying more on renewable resources such as wind and solar power.

Question 7 [4 marks]

Electrical Circuits and Components

Two identical fairy lights are wired in series with a battery.

State how the current through each lamp compares with the current through the other. State what happens to the other lamp if one filament breaks, and explain why. Then state why this makes it harder to locate the failed lamp than in a parallel circuit.

Question 8 [3 marks]

Domestic Electricity and Power

A vacuum cleaner is rated at 230 V, 6 A.

Calculate the power of the vacuum cleaner.

Question 9 [4 marks]

Electrical Circuits and Components

Two identical lamps are connected in parallel across a 6 V battery.

State how the potential difference across each lamp compares with the potential difference across the battery, and state how the current from the battery compares with the sum of the currents through each lamp. State and explain one advantage of wiring household lighting in parallel rather than in series.

Question 10 [3 marks]

Domestic Electricity and Power

A toaster is rated at 230 V, 4 A.

Calculate the power of the toaster.

Question 11 [4 marks]

Electrical Circuits and Components

Two resistors are connected in parallel across a 6 V battery. The first resistor has a resistance of 4 ohm, and the second has a resistance of 12 ohm.

Calculate the current through the first resistor and the current through the second resistor.

Question 12 [5 marks]

Atomic Structure and Radioactivity

Some radioactive nuclei decay by beta-minus emission.

Describe what a beta-minus particle is, and describe its penetrating power and ionising power compared with alpha and gamma radiation. State what happens to the mass number and the atomic number of a nucleus when it emits a beta-minus particle.

Question 13 [4 marks]

Energy Stores, Transfers and Conservation

A ball of mass 0.4 kg is dropped from rest from a height of 5 m above the ground. Assume all the gravitational potential energy is transferred to kinetic energy just before the ball hits the ground. Gravitational field strength g = 9.8 N/kg.

Calculate the speed of the ball just before it hits the ground.

Question 14 [5 marks]

Atomic Structure and Radioactivity

A sample of a radioactive isotope has a half-life of 4 hours. Initially there is 80 g of the isotope present.

Calculate the mass of the isotope remaining after 3 half-lives, and state how long this takes. State what is meant by half-life.

Question 15 [5 marks]

Electrical Circuits and Components

A 15 ohm resistor and a 25 ohm resistor are connected in series with an 8 V battery.

Calculate the total resistance of the circuit, the current flowing through the circuit, and the potential difference across the 15 ohm resistor.

Question 16 [5 marks]

Particle Model of Matter

A glass marble has a density of 2.5 g/cm^3 and a mass of 40 g.

Calculate the volume of the marble. Then convert this volume into m^3.

Question 17 [5 marks]

Energy Stores, Transfers and Conservation

A 2 kg block of copper is initially at 150 deg C and cools down, releasing 30,800 J of energy to the surroundings. The specific heat capacity of copper is 385 J/kg deg C.

Calculate the fall in temperature of the block, and hence calculate its final temperature.

Model solutions

Mark scheme for Question 1 [2 marks]
Question 1[2 marks]
Answer or workingMarks
13 protons, equal to the atomic numberB1
14 neutrons, since 27 - 13 = 14B1
Final answer: 13 protons and 14 neutrons
Mark scheme for Question 2 [2 marks]
Question 2[2 marks]
Answer or workingMarks
the gravitational potential energy storeB1
the kinetic energy storeB1
Final answer: From the gravitational potential energy store to the kinetic energy store.
Mark scheme for Question 3 [2 marks]
Question 3[2 marks]
Answer or workingMarks
the particles become much further apart, moving from a close, random arrangement to a widely spaced arrangementB1
particles moving freely and randomly in all directions rather than remaining close while moving past one another; do not require an increase in average speed during boilingB1
Final answer: Particles change from a close, disordered liquid arrangement to a widely spaced gas and move freely and randomly in all directions. Heating before boiling increases average speed; during boiling at constant temperature, average kinetic energy does not increase.
Mark scheme for Question 4 [2 marks]
Question 4[2 marks]
Answer or workingMarks
biomass being a renewable energy resourceB1
oil being non-renewable because it took millions of years to form and is being used up far faster than new oil can formB1
Final answer: Biomass is renewable; oil is non-renewable because it is used up far faster than it can be replaced.
Mark scheme for Question 5 [2 marks]
Question 5[2 marks]
Answer or workingMarks
direct current flowing in one direction onlyB1
the contrasting behaviour of alternating current: it repeatedly reverses direction; do not credit the direct-current definition againB1
Final answer: Direct current flows in one direction only. Alternating current repeatedly reverses direction.
Mark scheme for Question 6 [3 marks]
Question 6[3 marks]
Answer or workingMarks
one valid disadvantage: weather-dependent/intermittent output, limited ability to increase output on demand, high initial cost, large land requirement, visual impact or habitat disruptionB1
a second distinct valid disadvantage; weather-dependent output and inability to generate on demand from that same weather dependence count as one pointB1
a third distinct valid disadvantage from these or another physically valid exampleB1
Final answer: Output depends on suitable weather, so generation may not meet demand when needed. Building wind or solar farms has a high initial cost. Their land requirements can damage habitats. Other distinct valid disadvantages, such as visual impact, are acceptable.
Mark scheme for Question 7 [4 marks]
Question 7[4 marks]
Answer or workingMarks
the current through each lamp being the sameB1
stating that if one lamp's filament breaks, the other lamp also goes out (no current flows anywhere in the circuit)B1
explaining this happens because there is only one path for the current in a series circuit, so breaking it at any point stops the current everywhereB1
stating that all lamps being dark makes it difficult to identify which lamp has failedB1
Final answer: The current through both lamps is equal. If one filament breaks, both lamps go out because the circuit has only one path and it is now broken. Since both are dark, it is difficult to identify which lamp has failed.
Mark scheme for Question 8 [3 marks]
Question 8[3 marks]
Answer or workingMarks
power = potential difference x currentM1
substituting 230 x 6M1
power = 1380 WA1
Final answer: 1380 W
Mark scheme for Question 9 [4 marks]
Question 9[4 marks]
Answer or workingMarks
the potential difference across each parallel branch (lamp) being equal to the potential difference across the battery (6 V)B1
the total current from the battery being equal to the sum of the currents through each parallel branchB1
one valid advantage of parallel household lighting, such as independent switching/failure, or lamps operating at their intended brightness rather than becoming dimmer as more lamps are added in seriesB1
a corresponding distinct explanation: separate complete branches allow one branch to open without breaking the others; or, unlike parallel lamps, series lamps share the supply voltage, reducing their individual voltage and brightness. Do not credit the equal parallel voltage statement from the first point again without this series comparisonB1
Final answer: Each lamp has the battery potential difference (6 V); total current equals the sum of the branch currents. One lamp can fail or be switched off while the others stay lit, because each parallel branch has its own complete path through the supply.
Mark scheme for Question 10 [3 marks]
Question 10[3 marks]
Answer or workingMarks
power = potential difference x currentM1
substituting 230 x 4M1
power = 920 WA1
Final answer: 920 W
Mark scheme for Question 11 [4 marks]
Question 11[4 marks]
Answer or workingMarks
current = potential difference / resistance, applied to each resistorM1
substituting 6 / 4 for the first resistorM1
current through the first resistor = 1.5 AA1
current through the second resistor = 6 / 12 = 0.5 AA1
Final answer: 1.5 A through the 4 ohm resistor; 0.5 A through the 12 ohm resistor.
Mark scheme for Question 12 [5 marks]
Question 12[5 marks]
Answer or workingMarks
a beta-minus particle being a fast electron emitted from the nucleus; neutron-to-proton conversion is acceptable additional detail, not required for this identification markB1
beta radiation having a moderate penetrating power, being absorbed by a few mm of aluminium (but passing through paper)B1
beta radiation having a moderate ionising power, more ionising than gamma but less ionising than alpha radiationB1
stating the mass number of the nucleus stays the same when a beta particle is emittedB1
stating the atomic number of the nucleus increases by 1 when a beta particle is emittedB1
Final answer: A beta-minus particle is a fast electron emitted from the nucleus when a neutron changes into a proton. It penetrates more than alpha but less than gamma, and is stopped by a few millimetres of aluminium. It is more ionising than gamma but less than alpha. Mass number stays unchanged and atomic number increases by one.
Mark scheme for Question 13 [4 marks]
Question 13[4 marks]
Answer or workingMarks
GPE = m g h = 0.4 x 9.8 x 5 (= 19.6 J)M1
setting kinetic energy equal to GPE (= 19.6 J)M1
rearranging KE = 1/2 m v^2 to give v^2 = 2 x 19.6 / 0.4 (= 98)M1
v = 9.9 m/sA1
Final answer: 9.9 m/s
Mark scheme for Question 14 [5 marks]
Question 14[5 marks]
Answer or workingMarks
after each half-life the mass halves: 80, then 40, then 20, then 10M1
mass remaining after 3 half-lives = 10 gA1
time = number of half-lives x half-life = 3 x 4M1
time = 12 hoursA1
stating half-life is the time taken for the number of undecayed parent nuclei, mass of the parent isotope remaining, or activity to halve; accept background-corrected count rate halving with unchanged detector conditionsB1
Final answer: 10 g remains after 3 half-lives, which takes 12 hours. Half-life is the time taken for the number of undecayed parent nuclei, or their activity, to halve.
Mark scheme for Question 15 [5 marks]
Question 15[5 marks]
Answer or workingMarks
total resistance in series = sum of the individual resistances = 15 + 25M1
total resistance = 40 ohmA1
current = potential difference / total resistance = 8 / 40M1
current = 0.2 AA1
potential difference across the 15 ohm resistor = current x resistance = 0.2 x 15 = 3 VB1
Final answer: Total resistance = 40 ohm; current = 0.2 A; potential difference across the 15 ohm resistor = 3 V.
Mark scheme for Question 16 [5 marks]
Question 16[5 marks]
Answer or workingMarks
volume = mass / densityM1
substituting 40 / 2.5M1
volume = 16 cm^3A1
converting cm^3 to m^3, using 1 cm^3 = 1 x 10^-6 m^3M1
volume = 1.6 x 10^-5 m^3A1
Final answer: 16 cm^3 (1.6 x 10^-5 m^3).
Mark scheme for Question 17 [5 marks]
Question 17[5 marks]
Answer or workingMarks
change in temperature = energy transferred / (mass x specific heat capacity)M1
substituting 30800 / (2 x 385)M1
change in temperature = 40 deg CA1
final temperature = 150 - 40M1
final temperature = 110 deg CA1
Final answer: Fall in temperature = 40 deg C; final temperature = 110 deg C.

Build a free practice pack.

Pick the topics, add the student's name and print one PDF.