Revision Library
Choose a subject
Menu
Design and Technology
Need a new topic?
Missing a topic, found a bug, or want something added?
GCSE Design & Technology · Topic guide

Material properties and selection

Material properties describe how a material behaves in use. Selection means matching properties to a product requirement and comparing evidence from fair tests.

GCSEDesign and TechnologyAQA

Before you start

No prerequisites. You can start here.

Method

  1. Identify the job the product must do and the conditions it will face.
  2. Distinguish strength, stiffness, hardness and toughness before choosing a test.
  3. Compare results for samples tested under the same conditions.
  4. Explain how the preferred property helps the product perform its job.

Worked example

A casing needs to resist knocks, while its surface should resist scratches. Explain which properties to compare.

  1. Compare toughness to judge how well a material absorbs energy before fracturing.
  2. Compare hardness to judge resistance to surface scratching or indentation.
  3. Choose using both requirements; a hard surface does not establish good impact resistance.

Practice questions

Q1Which property concerns resistance to surface indentation?Show answer

Answer: Hardness.

Got it right?
Q2What does toughness describe?Show answer

Answer: The ability to absorb energy before fracturing.

Got it right?
Your answerWork it out on paper, then show the answer and mark yourself.
Q3How does stiffness differ from strength?Show answer

Answer: Stiffness concerns resistance to deformation; strength concerns resistance to failure under load.

Got it right?
Your answerWork it out on paper, then show the answer and mark yourself.
Q4Why should samples have matching dimensions when comparing bending?Show answer

Answer: Their dimensions affect bending, so matching them helps isolate differences between materials.

Got it right?
Your answerWork it out on paper, then show the answer and mark yourself.

Exam-style questions

Written in the style of a GCSE Design & Technology exam paper, with a full mark scheme.

Q1[2 marks]A panel bends very little in a load test. Explain why this does not establish that it will survive a drop.Show mark scheme

Tick each line you got.

Nothing ticked yet - 2 available

Got it right?
Q2[2 marks]Explain why a designer should check both mass and impact-test results for a portable case.Show mark scheme

Tick each line you got.

Nothing ticked yet - 2 available

Got it right?

Free printable worksheet

Want more practice on paper? Download the Material properties and selection worksheet pack - 5 pages of exam-style questions with a full mark scheme. Free to download, no card or account. Print it for personal and classroom use.

This topic is chapter 1 of GCSE Design and Technology Essentials, the whole course as one free printable PDF. Its worksheet is also chapter 1 of GCSE Design and Technology Topic Workbook 1 and chapter 1 of GCSE Design and Technology 10-Minute Tests, free printable practice books.

Other versions of this worksheet:

Keep going

Not quite what you needed?

Tell us what is missing on Material properties and selection, or which topic to write up next.

Build a full practice pack.