Worked question 5 - Mains Electricity, Power and Energy
Using this pack: mains electricity, power and energy
Revision Library
This pack covers UK mains electricity (ac and dc, the three-pin plug, wiring colours and safety devices), electrical power (P = V I and P = I^2 R), energy transfers (E = P t and E = Q V), and the National Grid. Every equation you need is given in the question itself - you are never expected to recall a physics equation from memory in this pack. Always show your working: convert units before you substitute (especially minutes or hours into seconds, and kW into W), and give a correct unit with every final answer. Parts labelled 'Higher tier only' and flagged htOnly in the mark scheme can be skipped if you are studying the Foundation tier.
Answer and mark scheme
Question 5
| Credit | Answer or working |
|---|---|
| B1 | (a) a thermometer (to measure the water's temperature/temperature change) |
| B1 | (a) a (mass/top-pan) balance (to measure the mass of the water) |
| B1 | (a) a stopwatch/timer (to measure the heating time); accept an insulated container/lid or a stirrer as alternative correct answers, up to three in total |
| M1 | (b) substitutes: E = 12.0 x 5.0 x 300 |
| M1 | (b) evaluates the product correctly |
| A1 | (b) E = 18 000 J (18 kJ) (cao) |
| M1 | (c) calculates the temperature rise: (delta)T = 38.0 - 20.0 = 18.0°C |
| M1 | (c) rearranges and substitutes: c = E / (m (delta)T) = 18000 / (0.20 x 18.0), ft from (b) |
| A1 | (c) c = 5000 J/(kg °C) (cao, ft) |
| B1 | (d) some of the electrical energy supplied was transferred to the surroundings/the cup/the heater and thermometer rather than to the water (heat loss), so the water's actual temperature rise was smaller than it would have been if all the energy had gone into the water; using the full electrical energy in the calculation therefore overestimates the specific heat capacity, oe |
| B1 | (e) insulate the cup further (e.g. use a lid and/or lagging/polystyrene) to reduce energy transferred to the surroundings, oe; accept other valid improvements, e.g. using a more powerful heater for a shorter time to reduce the proportion of energy lost |
| M1 | (f) substitutes: percentage difference = (5000 - 4200)/4200 x 100, ft from (c) |
| A1 | (f) 19% (awrt, ft) |
| B1 | (g) stirring ensures the water is heated evenly/reaches a uniform temperature throughout, so the thermometer gives an accurate reading of the whole sample's temperature, oe |
- (a) Answer: A thermometer, a (mass/top-pan) balance, and a stopwatch/timer.
- (b) Answer: 18,000 J (18 kJ)
- (c) Answer: 5000 J/(kg °C)
- (d) Answer: Some of the electrical energy was lost to the surroundings (not all of it heated the water), so the measured temperature rise was smaller than expected for that energy input, making the calculated specific heat capacity too high.
- (e) Answer: Insulate the cup better (e.g. add a lid and lagging) to reduce the energy transferred to the surroundings.
- (f) Answer: 19% (awrt)
- (g) Answer: Stirring spreads the heat evenly through the water so the temperature is uniform, giving an accurate thermometer reading.









